LIPO Battery 11.1V 1800mAh LB-012

Characteristics

• Lithium Polymer rechargeable battery for DARwIn-OP only.
• PCM is embedded to protect from overcharging, discharge, and excess current.
• Can not be used with the BIOLOID due to connector difference.
• Battery case/cover and extension cable not included.

What's included

• 1 x LIPO Battery 11.1V 1800mAh LB-012
  **Charger sold separately.

Specifications

Precautions

• Do not drop or fold any part of the battery or cables.
• Do not fold the end of the sutured portion.
• Do not apply heat, water, or any other liquid on the battery.
• Do not place it in the microwave, washing machine, or dryer.
• Do not use damaged batteries. (inflated, deformed, damaged, etc)
• Do not short circuit the polarity.
• Do not take the battery apart.
• When charging, make sure the battery is connected into the correct polarity.
• Do not charge when the battery is hot. Please charge after it has cooled off.
• Battery will not charge when connected to the robot.

* When the battery is not being used or fully charged, please do not have it connected to a device. 

STORAGE PRECAUTIONS:

• Detach the battery from the robot or controller when storing away.
• When storing away the battery for a long time, make sure the battery life is somewhere around 50%.
• Do not store it in wet or hot places.
• Please check your batery state every 4 months. Due to the internal circuit of the battery it will drain some watts over time so if you leave it stored for long periods it may discharge to a point where it cannot be charged again

Compatible products

• Robot : Robotis OP2, TurtleBot
• Charger : LIPO Battery Charger LBC-10

** NOT compatible with CM-series controllers.